copy of Men's signet ring brushed steel face round top 15mm customizable

copy of Men's signet ring brushed steel face...

Order it before 13:00 on Tuesday and receive it between 04-12-2025 and 08-12-2025 with La Poste • en courrier suivi Free!

copy of Men's signet ring brushed steel face round top 15mm customizable

Reference Chevalière-laser-T10

Last items in stock

€17.90

Tax included

Tax incl.

Here is a classic men's knight designed in brushed stainless steel with a round face of a dimension of 15mm x 14mm, ideal for customization.

Ring size

Tip to find the size of your ring

First, do not be frightened by the long visual effect of our guide, we assure you that determining your ring size will take you only a few minutes, see seconds:)

We will help you choose your ring size thanks to this complete guide, whether you already have a ring.

✦ IF YOU DON'T HAVE A RING ✦

Step 1: Cut a short piece of paper tape or a string. For a precise measure, wrap it around the finger to which you wear the ring. Be sure to tighten the ribbon or string around your finger.

Step 2: Where both ends of the ribbon overlap, make a marker (treat) using a pen or pencil.

Step 3: Measure the distance between the 2 markers to know the circumference of your finger (EU scale).

Step 4: The result will indicate the circumference of your finger ( EUROPE scale). The measure taken is corresponding in mm. So if for example you find the 62mm (6.2cm) measurement then your finger circumference is size 62, which also corresponds to the French size.

Refer to this table below ↓

---------------------------------------------------------------------------------------------

✦ IF YOU HAVE A RING ✦

OUR ADVICE : Do not refer to the print bags you will find on many sites. Why? Because when you print them, they are often on a bad scale. It is better to refer to the inner diameter of the ring you own and refer to the table of the letters below a little lower. Indeed, you already have a ring or ring that suits you, in this case, you just have to measure the inner diameter of it. To do this, follow the following steps:

Step 1: Put the ring on a flat surface and have a rule graduated in millimetres.

Step 2: Measure the inner diameter of the ring. Attention, we are talking about the inner diameter and not the circumference (see image below) For this, the rule must attach the left inner side and the right inner side of the ring. Be careful to keep the rule straight.

Step 3: Once the measurement is taken, you just need to refer to the ring size match chart and determine your ring size.

IMPORTANT: Your ring must be rounded so that there is the least margin of error possible. If the measurement falls between two sizes, it is advisable to choose the top size.