MEN'S RING TEEN STEEL JEWEL MONSTER DEMON WATER OCEAN BIKER GOTH GOTHIC NEW 2212

Order it before 14:00 of today and receive it between 02-05-2024 and 03-05-2024 with Lettre suivie Free!

Delivery Options

Carrier		Estimated Delivery
Lettre suivie		02-05-2024 - 03-05-2024

Carrier: Lettre suivie

Estimated delivery:
02-05-2024 - 03-05-2024

✖

Men's steel ring in the shape of a scaled monster demon sea ocean

Reference 3760388272204

€19.90

Tax included

Here is a ring depicting a stunning monster head in shiny steel and blackened by places on the ribbon to perfect the reality of the monster's scales and gills.

Ring size

Tip to find the size of your ring

First, do not be frightened by the long visual effect of our guide, we assure you that determining your ring size will take you only a few minutes, see seconds:)

We will help you choose your ring size thanks to this complete guide, whether you already have a ring.

✦ IF YOU DON'T HAVE A RING ✦

Step 1: Cut a short piece of paper tape or a string. For a precise measure, wrap it around the finger to which you wear the ring. Be sure to tighten the ribbon or string around your finger.

Step 2: Where both ends of the ribbon overlap, make a marker (treat) using a pen or pencil.

Step 3: Measure the distance between the 2 markers to know the circumference of your finger (EU scale).

Step 4: The result will indicate the circumference of your finger ( EUROPE scale). The measure taken is corresponding in mm. So if for example you find the 62mm (6.2cm) measurement then your finger circumference is size 62, which also corresponds to the French size.

Refer to this table below ↓

---------------------------------------------------------------------------------------------

✦ IF YOU HAVE A RING ✦

OUR ADVICE : Do not refer to the print bags you will find on many sites. Why? Because when you print them, they are often on a bad scale. It is better to refer to the inner diameter of the ring you own and refer to the table of the letters below a little lower. Indeed, you already have a ring or ring that suits you, in this case, you just have to measure the inner diameter of it. To do this, follow the following steps:

Step 1: Put the ring on a flat surface and have a rule graduated in millimetres.

Step 2: Measure the inner diameter of the ring. Attention, we are talking about the inner diameter and not the circumference (see image below) For this, the rule must attach the left inner side and the right inner side of the ring. Be careful to keep the rule straight.

Step 3: Once the measurement is taken, you just need to refer to the ring size match chart and determine your ring size.

IMPORTANT: Your ring must be rounded so that there is the least margin of error possible. If the measurement falls between two sizes, it is advisable to choose the top size.